Page 88 - FireClass 2015-2016
P. 88
Ancillary Loop Modules Housing
Quad Relay Module
The FC410QRM Quad Relay Module is designed to provide four potential free relay
changeover outputs. The outputs are monitored with parallel contacts of the relays.
The outputs can be connected to an Auxiliary Voltage source and its voltage can be
monitored. The FC410QRM has an integral FireClass loop isolator. When a section
of the loop adjacent is shorted, the isolator trips, isolating the shorted section, and
illuminating a yellow LED. This status remains until the short is removed.
The FC410QRM must be fitted in a control enclosure or any distributor enclosure.
The FC410QRM will preferably be mounted via a DIN rail. Alternatively, it can
be directly fixed on the rear side of the enclosure. Furthermore, all outputs are
configurable to the HVR - mode (High Voltage Relay), which allows connection of
up to four HVR800 modules for switching e.g. 240V loads galvanic isolated.
Product Order Codes
FC410QRM 555.800.773
Line Isolator Module
The FC410LI Line Isolator Module is designed to be used on the FireClass
addressable controller loop. It monitors the line condition and when detecting a
short circuit will isolate the affected section whilst allowing the rest of the loop to
function normally. The purpose of the FC410LI Line Isolator Module is to ensure
that, on a looped addressable system, no short circuit fault can disable more
detection devices than would be lost on a conventional non-addressable fire circuit.
Product Order Codes
FC410LI 545.800.704
Door Control Module
When activated, either by a fire signal or by a fault or isolation within the fire door
zone, the FC410TSM will interrupt the supply to the door holders and the doors
under control of the module will close. The module has the provision to monitor
a contact to report to the fire controller ifthe door fails to close. The module also
includes a built-in line isolator.
Product Order Codes
FC410TSM 555.800.769
Quad Relay Module
The FC410QRM Quad Relay Module is designed to provide four potential free relay
changeover outputs. The outputs are monitored with parallel contacts of the relays.
The outputs can be connected to an Auxiliary Voltage source and its voltage can be
monitored. The FC410QRM has an integral FireClass loop isolator. When a section
of the loop adjacent is shorted, the isolator trips, isolating the shorted section, and
illuminating a yellow LED. This status remains until the short is removed.
The FC410QRM must be fitted in a control enclosure or any distributor enclosure.
The FC410QRM will preferably be mounted via a DIN rail. Alternatively, it can
be directly fixed on the rear side of the enclosure. Furthermore, all outputs are
configurable to the HVR - mode (High Voltage Relay), which allows connection of
up to four HVR800 modules for switching e.g. 240V loads galvanic isolated.
Product Order Codes
FC410QRM 555.800.773
Line Isolator Module
The FC410LI Line Isolator Module is designed to be used on the FireClass
addressable controller loop. It monitors the line condition and when detecting a
short circuit will isolate the affected section whilst allowing the rest of the loop to
function normally. The purpose of the FC410LI Line Isolator Module is to ensure
that, on a looped addressable system, no short circuit fault can disable more
detection devices than would be lost on a conventional non-addressable fire circuit.
Product Order Codes
FC410LI 545.800.704
Door Control Module
When activated, either by a fire signal or by a fault or isolation within the fire door
zone, the FC410TSM will interrupt the supply to the door holders and the doors
under control of the module will close. The module has the provision to monitor
a contact to report to the fire controller ifthe door fails to close. The module also
includes a built-in line isolator.
Product Order Codes
FC410TSM 555.800.769
